iCare Door Installation for iOS (iphone and ipad)
Replied by : support@icaresoftware.com
I. Install the iCare Door Switch
- Mount the Switch behind the lobby wall near the door but out of reach for people walking in.
- Finish the wiring as given in the diagram below. Please note the following tips:
- On the left side connect the wire to the top screw
- On the right side connect the wire to the middle screw
- Make sure the power supply for the door strike is 15-24V DC only
Wiring Diagram iCare Door Switch supplied by Orgamation 5V power supply supplied by Orgamation
To door strike
15 -24V DC for door strike
Il. Install and Connect the iCare Door App
- Download the iCare Door App from the Apple App Store on your iPad (it can be installed on an iPhone also)
- Open the App on the iPad. Click on Connect Device given at the bottom of the screen.
- A list of available Bluetooth devices will show. Select LazyBone-B (or iCare Door, if available)
|
Back Select BLE Device |
|
|
|
|
|
MIOAQY5 |
|
M234 LaserJet |
|
LazyBone-B |
|
M234 LaserJet |
|
Inspire 2 |
- The Door App needs to stay connected always for the relay switch to work. To do so, go to Mode and make sure both flags are OFF.
|
100% |
|
|
- Go to Settings on the iPad (or iPhone) and tap on the iCare Door App. Turn ON Background App Refresh. (This will let the Door App/Switch work even when the iPad goes to sleep mode.)
Ill. Connect iCare Lobby App to the Door App
- Open Chrome Browser on the iPad. (Other browsers may work without a problem but Chrome is recommended.)
- In the address bar type, lobby.icaresoftware.com.
- Check Use iCare Door Opener and tap on the Setting icon.
- Enter Device ID as given in the Door App screen. Tap on Proceed.
- Enter your Lobby Credentials and open the Lobby App. (Lobby credentials are given in your iCare App > Settings > Step 7.)
When Does the Door Open?
The door will open when anyone checks in or out through the Lobby App, Check-ln App, or Parent App.
The following conditions apply:
Staff should be active.
For parents and other contacts of children, in the Profile Page > Contacts Tab, the Can Pick Up flag should be ON.
